EasyManua.ls Logo

Panasonic CQ-D1703W

Panasonic CQ-D1703W
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
45
1
E
N
G
L
I
S
H
CQ-D1703W
44
Common (continued)
The safety device works.
aConsult your dealer, or your nearest Panasonic Service Center.
The power of the unit
fails unintentionally.
The plus and minus terminals at right and left channels of speakers are con-
nected reversely.
aPerform the speaker wiring in accordance with the wiring diagram.
The sound field is not
clear in the stereo
mode. Central sound is
not settled.
The speaker wiring is reversed between right and left.
aPerform the speaker wiring in accordance with the wiring diagram.
The speaker channels
are reversed between
right and left.
Problem
Possible cause
a
Possible solution
Radio
The contact of the battery lead is poor, or the battery lead is not always
powered.
aMake sure that the battery lead is connected securely, and preset sta-
tions again.
Preset stations cannot
be stored.
The number of receivable stations is less than 6.
aMove to an area where receivable stations number is maximum, and try
presetting.
The number of auto
preset stations is less
than 6.
Antenna installation or wiring of antenna cable is faulty.
aCheck whether the antenna mounting position and its wiring are correct.
In addition, check to see whether the antenna ground is securely con-
nected to the chassis.
No power is supplied to the antenna amplifier (when using a film antenna, etc.).
aCheck the wiring of the antenna battery lead.
Poor reception or
noise
Problem
Possible cause
a
Possible solution
The battery is inserted in the wrong direction. A wrong battery is inserted.
aInsert a correct battery in the correct direction.
The battery is weak.
aReplace the battery with new one.
The aiming direction of the remote control unit is wrong.
aAim the remote control unit at the sensor of the unit and press buttons.
The sensor is exposed to direct sunlight. (The remote control unit may not be
operable when the sensor is exposed to direct sunlight. In such a case, the
system is not faulty.)
aBlock off sunlight to the sensor.
No response to press-
ing buttons
Remote control unit
Problem
Possible cause
a
Possible solution

Related product manuals