[SRC/PWR]
[s] [d]
9
10
CQ-VW100W
TV Tuner Control
English
Preparation:
¡Connect a TV tuner (CY-TUP133W/CY-TUN133W,
option) to the unit.
¡It is required to install the TV antenna to receive TV
broadcasts.
¡For receiving TV broadcasts, stop your car where
there is no obstacle to broadcast reception around.
Operations
Channel
Selection
Channel Seeking
Displaying TV Menu
Tuning
……
Touch/Press and hold
–
–
–
Selecting an Item on
the TV Menu
Band Selection
TV 1 TV 2
Calls up the menu of the tuner.
To cancel, touch again.
Left/right
Up/down
Up
Down
Up
Down
Source Button
To switch Operation Screen ON, touch the center of
touch panel.
Channel selection/
Channel seeking
TV menu
Band selection
Preset
channel
selection
q
Touch
“
Source Button
”
.
d
w
Touch
(TV) on the
Source Selection
Screen.
(Content varies with
connected devices)
Source Selection
Note:
¡
CY-TUP133W/CY-TUN133W is an analog TV-specific
tuner.
¡
If the analog broadcast system is replaced with the dig-
ital broadcast system in a country or area where CY-
TUP133W/CY-TUN133W is used, TV broadcasts can-
not be received.
¡
Inquire about the termination of analog broadcasting to
[d]
[
s]
[
d]
[
s]
the authorities concerned in the country or area where
CY-TUP133W/CY-TUN133W is used.
¡
For the operations of the TV tuner with its remote con-
trol, aim the remote control at the remote control sen-
sor of this unit.
¡
The remote control of the TV tuner (CY-TUP133W/CY-
TUN133W, option) cannot turn on or off the power of
the TV tuner.
Press
[SRC/PWR]
to change to the
desired mode.
To Next Page
Loading...
