15
16
CQ-VX100N
English
Bluetooth Unit Control (Audio)
Display of connection state
¡ (Connected model):A Bluetooth audio device is con-
nected.
¡ No Connection: Requires connection because no con-
nection is established.
¡ No Paired Device: Requires registration because no
registration is performed.
To switch Operation Screen ON, touch the center of
touch panel.
Preparation:
¡Connect the Bluetooth Unit (CY-BT200N, option).
Note:
¡ The Bluetooth audio devices that can be played with this unit must be compatible with A2DP (Advanced Audio
Distribution Profile) or AVRCP (Audio/Video Remote Control Profile).
¡ Please refer to the operating instructions of the Bluetooth unit (CY-BT200N) for further information regarding
Bluetooth.
¡ We shall not guarantee all the functions of the Bluetooth audio device to be connected. When operations cannot be
performed via this unit, operate the system via the Bluetooth audio device.
¡ Be aware that the battery of the Bluetooth compatible device drains faster if the Bluetooth compatible device is con-
nected to this unit.
¡ Some Bluetooth devices may become unstable (such as no sound output) in the Bluetooth audio mode after deleting
both the hands-free phone and audio pairings and then pairing the audio mode again.
If such a case occurs, delete the pairing and esablish the pairing again.
q
Touch
“
Source Button
”
.
d
w
Touch
(Bluetooth) on
the Source
Selection Screen.
(Content varies with
connected devices)
Bluetooth Audio Mode Selection
Press
[SOURCE]
to change to the desired
mode.
Bluetooth Audio Settings
Registration of the
Bluetooth audio device
with this unit
–
–
––
q The setup screen appears.
w The registration screen appears.
d
d
d
e Set up the Bluetooth compatible devices to be regis-
tered with this unit. (Touching stops reg-
istration.)
d
Bluetooth
setting but-
ton
Hands-Free button(
a page 18)
Disconnect
button
Operation Buttons
Touching calls the last screen.
To Next Page
Loading...
