Panasonic cs-903ke - Tool Operating Modes and Switches

- 10 -
●Itwill bedifficult to remove the
clutch lock cover from the drill if
you push on the side of the cover
while pulling it off.
Using the LED Light
Before the use of LED light, always
pull the power switch once.
Press the LED light on button.
The light illuminates with very low cur-
rent, and it does not adversely affect
the performance of the tool during
use or its battery capacity.
CAUTION:
• The built-in LED light is designed
to illuminate the small work area
temporarily.
• Do not use it as a substitute for a
regularashlight,sinceitdoesnot
have enough brightness.
• LED light turns off when the tool
has not been used for 5 minutes.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
ofproceduresotherthanthosespeciedherein
may result in hazardous radiation exposure.
Bit-locking Function
With the switch at off and the bit lock-
ed in place, the tool can be used as a
manual screw-driver - up to 14.7 N·m
(150 kgf-cm, 130 in-lbs).
There will be a little play in the driving
shaft, but this is not a malfunction.
Main Switch (ON/OFF)
Push the upper half of the switch for
forward rotation, or the lower half for
reverse rotation.
Forward
Forward
Reverse
Reverse
Speed Selector Switch
To suit the application of this tool, two
different rotational speeds are avail-
able. Depending upon use, either the
high or low speed should be select-
ed.
LOW
HIGH
Speed selection Torque
LOW 200 min
-1
(rpm) High
HIGH 600 min
-1
(rpm) Low
CAUTION:
• Check speed selector switch before
use.
• Do not operate the speed selector