– 17 –
CS-A120TE
Operation Details
3) Detail of Sleep Mode
Sleep Mode operates to match your sleeping condition.
1 At Cooling or Soft Dry operation
When you set the sleep Mode (E), the following movement will
start to avoid overcooling.
• The fan speed is automatically set to low.
• The setting temperature will be rise by 1°C at the start of
operation and by 1°C one hour later.
• The Automatic Restarting Control is changed from 7 minutes
to 5 minutes.
• The operation will stop after 5 hours.
2 At Heating operation
When you set the sleep Mode (E), the following movement will
start to avoid overheating.
• The fan speed is automatically set to low.
• The setting temperature will be dropped by 2°C at the start of
operation and by 3°C one hour later.
• The operation will stop after 5 hours.
4) Heating Mode Operation
When selecting the Heating (#) Mode Operation, the unit will
operate according to the setting by the Remote Control and the
operation is as the following.
1Room temperature can be set in 1°C steps in the range of 16
to 30°C. Relationship between the remote control tempera-
ture adjustment knob and operation is shown in the diagram
below.
2Taking the difference between the room temperature
distribution and intake air temperature, heating ON tem-
perature is set 3°C higher than the remote control setting.
(3°C higher than
the set temp.)
Untitled-10 6/19/00, 6:38 PM17
To Next Page
Loading...
