Panasonic CS-C125KA - Helpful Information; Auto Restart Control; Timer Setting; Thunder and Lightning

25
HELPFUL INFORMATION
 !"
Auto Restart Control
• If power is resumed after a power failure, the operation will restart
automatically after 3 - 5
1
/2 minutes.
• Operation will be automatically restart under the previous operation mode and
airflow direction when power is resumed as the operation is not stopped by
remote control.
 !"#
•  !"#$%&'()!*+,=PR
N
L
O
= !"#$%&'
•  !"#$%&'()*+,-./0123456789:;<=>
 !"#
Timer Setting
 !
• When power failure occurs, the timer setting is cancelled. Once power is
resumed, reset the timer.
•  !"#$%&$'(&)*+,-./01 23456(&&$'-
POWER FAILURE
======= !
Auto Operation Button
 !"#
P
OW
ER
E
C
O
N
O
M
Y
P
O
W
E
R
F
U
L
SLEEP
TIM
ER
Thunder and Lightning
• This air conditioner is equipped with a built-in surge
protective device. However, in order to further
protect your air conditioner from being damaged by
abnormally strong lightning activity, you may switch
off the main power supply and unplug from power
socket.
 !"
•  !"#$%&'()*+,#-./0
 !"#$%&'()*+,-./0
 !"#$%&'($)*
■ Automatic Operation
• If the remote control fails to function or misplaced, press Auto Operation button
for Automatic operation.
• The Automatic operation will be activated immediately once the Auto operation
button is pressed. However, temperature cannot be adjusted in this operation.
• The power LED on the indoor unit blinks until the operation mode is selected
automatically.
• To cancel this operation, press once more.
■  !
•  !"#$%&'()*+,-./0123.4567012389:
•  !"#$%&'("#$%)*+,#-./(01234(5)678
 !
•  !"#$%&'()*+,-./0123456789:;<=
•  !"#$%&'()*"+,-.
■ Remote Control Signal Receiving Sound
• To switch off the beep (Signal Receiving Sound), press this Auto Operation
button for 10 seconds continuously or longer.
“Beep”, “beep” sound will be heard at the tenth seconds.
Note: “Beep” sound will be heard at the fifth seconds; However please press
continuously until you heard “beep” , “beep” sound.
• Repeat this, if you want to switch on the Signal Receiving Sound.
■  !"#$%&
•  !"#$%&'()*%+,-./0123456789=NM= !
 !
=NM= !"#$%&'(%&')*
 !"=R= !"#$%&'()*+,-./0123456%$%
 ! "#$%
•  !"#$%&'()*+,-./0
* Note: If you press this button continuously for 5 to 10 seconds, Test Run
operation will be performed. A “beep” sound will be heard at the fifth seconds, to
identify the starting of Test Run operation.
(This is for Servicing purpose only.)
*  !"#$%&'()*+=R==NM= !"#$%&'()*+=R= !
 !"#$%&'()*+,-./0
 !"#$%&'