36
• Detach 5 connectors as labeled from the electronic
controller. Then, pull it out slowly while pressing the fastener
to the right. (Fig. 5)
Fig. 5
13.1.3. To remove the Discharge Grille
• Remove the drain hose from the discharge grille. (Fig. 6)
• Remove the screw holding the discharge grille. (Fig. 6)
• Then pull the discharge grille downward gently to dismantle
it. (Fig. 6)
• Remove 3 screws holding the control board. Press down the
control board fastener and the whole control board can be
removed. (Fig. 6)
Fig. 6
13.1.4. To remove the Cross Flow Fan and Indoor Fan Motor
• Remove the bearing by pulling it out gently. (Fig. 7)
• Push the hook to the left and lift up the evaporator.
• Then, remove cross flow fan by pulling both cross flow fan
and fan motor.
Fig. 7
Fig. 8
To Next Page
Loading...
