Panasonic CS-E9EKK - Disassembly and Assembly Instructions; Indoor Electronic Controllers, Cross Flow Fan and Indoor Fan Motor Removal Procedures

35
13 Disassembly and Assembly Instructions
13.1. Indoor Electronic Controllers, Cross Flow Fan and Indoor Fan Motor
Removal Procedures
13.1.1. To remove the Front Grille
• Lift to open the vertical vent gently. (Fig. 1)
• Remove 2 caps and 2 screws at the bottomof discharge
vent. (Fig. 1)
• Hold both sides of the frontgrille and remove it by pullingup
and towards you gently. (Fig. 1)
• Remove the earth wire. (Fig. 2)
• Remove the control board cover complete screw. (Fig. 2)
• Remove the control board complete. (Fig. 2)
Fig. 1
Fig. 2
13.1.2. To remove the Main Electronic Controller
• Remove the control board cover. (Fig. 3)
• Remove the screw holding the indicator. (Fig. 3)
• Press the fastener to the right and take out the particular
piece. Pull out the main electronic controller half way.
(Fig. 4)
• Remove the red wire from the terminal board. (Fig. 4)
• Remove the connector from the indicator. (Fig. 4)
• Remove 2 screws (earth wire). (Fig. 4)
Fig. 3
Fig. 4