31
7. Remove the tapes and connect the power supply cord and connecting cable between indoor unit and outdoor unit according
to the diagram below.
8. Secure the power supply cord and connection cable onto the control board with the holder.
9. Close grille door by tighten with screw and close the front panel.
Note:
• Isolating Devices (Disconnecting means) should have minimum 3.0mm contact gap.
• Ensure the colour of wires of outdoor unit and the terminal Nos. are the same to the indoor's respectively.
• Earth wire shall be Yellow/Green (Y/G) in colour and longer than the other AC wires as shown in the figure for the electrical
safety in case of the slipping out of the cord from the anchorage.
To Next Page
Loading...
