33
To learn more... / Cleaning instructions
Cleaning instructions
To ensure optimal performance of the unit,
cleaning has to be carried out at regular
intervals. Dirty unit may cause malfunction
and you may retrieve error code “H 99”.
Please consult authorised dealer.
• Switch off the power supply and unplug before
cleaning.
• Do not touch the aluminium fi n, sharp parts may
cause injury.
• Do not use benzine, thinner or scouring powder.
• Use only soap (
pH 7) or neutral household
detergent.
• Do not use water hotter than 40 °C / 104 °F.
Indoor unit
nanoe
TM
-G Generator
Once every 2 weeks
• Clean with dry cotton bud.
• Do not touch during operation.
Air fi lters
Once every 2 weeks
• Wash/rinse the fi lters gently
with water to avoid damage
to the fi lter surface.
• Dry the fi lters thoroughly under shade, away
from fi re or direct sunlight.
• Replace any damaged fi lters.
Remove air fi lter Attach air fi lter
Insert into the unit
Indoor unit
Wipe the unit gently with a soft, dry
cloth.
Coils and fans should be cleaned
periodically by authorised dealer.
Outdoor unit
Clear debris that surround the unit.
Clear any blockage from drain pipe.
Front panel
Wash gently and dry.
How to remove front panel
Raise over
horizontal
level
1
Pull upward
2
Horizontal
Close it securely
2
Match and push in
nanoe-G
AUTO
OFF/ON
1
Hold
horizontally
3
Close down
4
Press both ends and center of the front panel
nanoe-G
AUTO
OFF/ON
Aluminium fi n
Front panel
Air fi lters
nanoe
TM
-G Generator
English
To Next Page
Loading...
