Panasonic CS-RE9SKA - Adjusting Airflow and Fan Speed; Timer and Auto Restart Settings

15
English How to use
Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after a period
of time with previous operation mode and airfl ow
direction.
• This control is not applicable when TIMER is set.
POWERFUL/
QUIET
To switch between powerful &
quiet
QUIETPOWERFUL NORMAL
POWERFUL: To reach temperature quickly
POWERFUL/QUIET
• This operation stops automatically after 15 minutes.
QUIET: To enjoy quiet operation
POWERFUL/QUIET
• This operation reduces airfl ow noise.
FAN SPEED
To select fan speed
(Remote control display)
AUTO
FAN
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
AIR SWING
To adjust vertical airfl ow direction
(CS-RE9SKA, CS-RE12SKA)
(Remote control display)
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the fl ap swings
up/down automatically.
• In HEAT mode, if AUTO is set, the horizontal fl ap is
fi xed at the predetermined position.
• Do not adjust the fl ap by hand.
AIR SWING
To adjust airfl ow direction
(CS-RE18SKA, CS-RE24SKA)
(Remote control display)
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the fl aps swings
left/right and up/down automatically.
• In HEAT mode, if AUTO is set, the horizontal fl ap is
fi xed at the predetermined position. The vertical fl ap
swings left/right after the temperature rises.
• If manual is set, the horizontal and vertical fl ap are
fi xed at the predetermined position.
• Do not adjust the fl ap by hand.
To set the timer
2 sets of ON and OFF timers are available to turn
ON or OFF the unit at different preset times.
ON
OFF
SET
CANCEL
123
TIMER
C
AN
C
E
L
3
TIMER
1 2 3
1
Select ON or OFF timer Example:
OFF at 22:00
• Each time pressed:
OFF
Cancel
2
Set the time
2
3
Confi rm
SET
TIMER
• To cancel ON or OFF timer, press
ON
or
OFF
to
select respective or then press
CANCEL
.
• If timer is cancelled manually or due to power
failure, you can restore the timer again by
pressing
ON
or
OFF
to select respective or
then press
SET
.
• The nearest timer setting will be displayed and
will activate in sequence.
• When ON Timer is set, the unit may start earlier
(up to 30 minutes) before the actual set time
in order to achieve the desired temperature on
time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For
clock setting, please refer to Quick guide.
Note
POWERFUL/
QUIET
,
nanoe-G
,
SLEEP
• Can be activated in all modes and can be
cancelled by pressing the respective button
again.
POWERFUL/
QUIET
• Cannot be selected at the same time.