To Next PageTo Next PageWhy is the electric current higher than specified in my Panasonic Air Conditioner?
If the electric current during operation of your Panasonic Air Conditioner is higher than specified, it could be due to a dusty condenser preventing heat radiation. Consider measuring the electric current to check. Note that the current might also be lower than specified.
Why is gas side pressure high during cooling mode in Panasonic CS-RZ50WKRW Air Conditioner?
High gas side pressure during cooling mode in your Panasonic Air Conditioner may be caused by an inefficient compressor. Measuring gas side pressure is advised. Note that the pressure might also be low.
General| Cooling Capacity | 5.0 kW |
|---|---|
| Heating Capacity | 6.0 kW |
| Refrigerant | R32 |
| Power Supply | 220-240 V, 50 Hz |
| Energy Efficiency Class Cooling | A++ |
| Energy Efficiency Class Heating | A+ |
| Energy Efficiency Ratio (EER) | 3.50 |
| Indoor Unit Noise Level | 19 dB (Low) - 42 dB (High) |
| Outdoor Unit Noise Level | 45 dB (Low) - 55 dB (High) |
| Energy Efficiency Ratio (Cooling) | 3.50 |
| Noise Level (Indoor) | 19 dB (Low) - 42 dB (High) |
| Noise Level (Outdoor) | 45 dB (Low) - 55 dB (High) |
Step-by-step guide for correctly installing batteries into the remote control unit.
Instructions on how to set the clock on the remote control for accurate time display.
Explanation of warning and caution symbols used in the manual to denote potential hazards.
Guidelines for safe installation and operation of indoor and outdoor units to prevent injury.
A checklist of common issues and checks to perform before contacting a service technician.
Explanation of how to retrieve error codes using the remote control and a list of diagnostic codes.
