Panasonic CS-S9MKQ - Air Quality and Purification Features; Energy Saving and Comfort Features

ENGLISH
7
NOTES
NOTES
PATR
O
L/
,
POWERFUL/
QUIET
,
AUT
O
COMFORT
,
POWERFUL/
QUIET
,
AUT
O
COMFORT
,
• Can be activated in all modes and can be cancelled by
pressing the respective button again.
• Cannot be selected at the same time.
• Cannot be activated during “MILD DRY COOLING”
operation is activated.
6
TO ENJOY CLEAN & FRESH AIR
PATROL/
PATROL NORMAL
PATROL - To monitor air quality
• Detects air quality; e-ion operation
activates when air quality is at dirty
level.
• Regardless of air quality, to
maintain air freshness e-ion
activates automatically (PATROL
SENSOR indicator turns red) when:
- 2 minutes after the unit is on, or
- exceeds 4 hours at clean level.
Indicator Air Quality
Blue Clean
Orange Moderate
Red Dirty
• Can be activated even when the unit is turned off.
• Patrol starts automatically with the unit switched on with
OFF/ON
.
- To freshen and purify the air
• Generates negative ions to produce fresh air effect and
attract dust which will then be captured at the positively
charged e-ion fi lters.
• Can be activated even when the unit is turned off. In this
condition, fan speed and air swing can not be adjusted.
7
TO IMPROVE HUMIDITY AND MOISTURE LEVEL
• This operation reduces air dryness and provides you with
a comfortable living environment during COOL mode only.
• When vertical airfl ow direction is set to AUTO, it stops at
lower position to avoid cold air contact. However, you can
adjust the louver direction manually.
8
TO SWITCH BETWEEN
POWERFUL & QUIET
POWERFUL/QUIET
POWERFUL/
QUIET
QUIETPOWERFUL NORMAL
PO
WERF
U
L
TO REACH TEMPERATURE QUICKLY
• This operation will stop automatically after 4
hours.
Q
UIET
TO ENJOY QUIET OPERATION
• This operation reduces airfl ow noises.
• When this operation is activated, the
indicator brightness will be dimmed.
9 10
TO MONITOR HUMAN PRESENCE &
ACTIVITY FOR ENERGY SAVING &
COMFORT
To optimize energy
saving
AUTO
COMFORT
To maximize comfort
AUTO COMFORT
• When either operation is activated, the unit will start
to initialize for approximately 1 minute. Human activity
indicator is blinking in sequence.
• After initialization, the human activity sensor will start
to detect the level of heat source & movement, the unit
adjusts the temperature and airfl ow to keep you comfort
consistently.
Heat Source & Movement
Normal
HighLow
Set Temperature
None
Set Fan Speed
≤ Medium
Fan
+1 tap*
+2°C
-1°C
+1°C
+1 tap
* For first 15 minutes or until set temperature is reached.
• Human activity sensor will also scan for area of heat
source and movement in a room.
Human activity indicator Heat source & movement
At left area of the room
At right area of the room
At centre area or multiple areas
of the room.
• The unit will determine the heat source & movement
hotspot, and automatically adjust horizontal airfl ow
direction louver either fi x at predetermined position or
swing left/right.
Detection area (top view)
7m
120º
• When manual AIR SWING is selected, the ECONAVI
and AUTO COMFORT operation will be cancel.
• Sensor may not detect moving objects further than 7m
away or beyond detection angle.
• Sensor sensitivity is infl uenced by indoor unit location,
movement speed, temperature range, etc.
• The sensor may mistakenly detects pets, sunlight, certain
lighting, fl uttering curtains and light refl ection as human
being.