5
TO SET THE TIMER
• 2 sets of ON and OFF timers are available to turn ON
or OFF the unit at different preset time.
• Complete below procedures to set each timer:
ON
OFF
1
Cancel
Cancel
2
TIMER
SET
3
Select ON or OFF timer
Set the
time
Confi rm
• Example of application at living room:
Morning: ON
at 07:00 (Wake up)
OFF
at 08:00 (Out for work)
Evening: ON at 17:00 (Back home)
OFF at 22:00 (Sleep)
• To cancel ON or OFF timer, press
ON
or
OFF
to
select respective or then press
CANCEL
.
• If timer is cancelled manually or due to power failure,
you can restore the timer again by pressing
ON
or
OFF
to select respective or then press
SET
.
• Upcoming timer will be displayed and will be activated
in sequence.
• When ON Timer is set, the unit may start earlier (up
to 15 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For clock
setting, please refer to Remote Control Preparation
on the back cover.
8
TO REACH TEMPERATURE QUICKLY
• This operation will stop automatically
after 20 minutes.
POWERFUL
9
TO ENJOY QUIET OPERATION
• This operation reduces airfl ow noises.
QUIET/ECONOMY
10
Press and hold for 5 seconds to dim or restore the
unit’s indicator brightness.
11
Press and hold for approximately 10 seconds to
show temperature setting in °C or °F.
12
Press to restore the remote control’s default setting.
13
Not used in normal operations.
NOTES
,
POWERFUL
,
ECONOMY
• Can be activated in all modes and can be cancelled
by pressing the respective button again.
,
POWERFUL
,
ECONOMY
• Cannot be selected at the same time.
INFORMATION
FOR SEASONAL INSPECTION AFTER EXTENDED NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select Cooling operation. After 15 minutes of
operation, it is normal to have the following temperature difference between
air inlet and air outlet vents:
Cooling: ≥ 8°C
FOR EXTENDED NON-USE
• Turn off the power supply and unplug.
• Remove the remote control batteries.
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY AND UNPLUG
then please consult authorized dealer under the
following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote
control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
To Next Page
Loading...
