English
17
See "To learn more..." for details.
To optimise energy saving
To purify the air
nanoe-G
•
nanoe-G starts automatically when the unit is
turned on with
OFF/ON
OFF/ON
.
•
Can be activated even when the unit is turned off.
In this condition, the unit will operate as a fan with
AUTO fan speed and flap swing.
To deactivate viruses/bacteria on the filter
nanoe-G POWER
•
After the unit is turned off, the nanoe-G in-filter
deactivation may activate up to 150 minutes.
Turning on the unit cancels this operation.
AIR SWING
To adjust airflow direction
(Remote control display)
•
Keeps the room ventilated.
•
In COOL/DRY mode, if AUTO is set, the flaps
swings left/right and up/down automatically.
•
In i AUTO-X mode, if AUTO is set, the horizontal
flap is fixed at the lower position and shift to the
upper position after reaches set temperature. The
vertical flap movement depends on human activity
sensor. If manual is set, the horizontal and vertical
flap are fixed at the predetermined position.
•
Do not adjust the flap by hand.
To set the timer
2 sets of ON and OFF timers are available
to turn ON or OFF the unit at different preset
times.
ON
OFF
SET
TIMER
CANCEL
AN
E
1 2 3
1
Select ON or OFF
timer
Example:
OFF at 22:00
• Each time pressed:
OFF
Cancel
2
Set the time
3
Confirm
SET
TIMER
• To cancel ON or OFF timer, press
ON
or
OFF
to select respective or then press
CANCEL
.
• If timer is cancelled manually or due to power
failure, you can restore the timer again by
pressing
ON
or
OFF
to select respective or
then press
SET
.
• The nearest timer setting will be displayed and
will activate in sequence.
• When ON Timer is set, the unit may start
earlier (up to 15 minutes) before the actual
set time in order to achieve the desired
temperature on time.
• Timer operation is based on the clock set in
the remote control and repeats daily once set.
For clock setting, please refer to Quick guide.
Note
QUIET
,
SLEEP
,
,
QUIET
• Can be activated in COOL and DRY mode and
can be cancelled by pressing the respective
button again.
• Cannot be selected at the same time.
Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after a period
of time with previous operation mode and airflow
direction.
• This control is not applicable when TIMER is set.
How to use
ACXF55-04370_YZ0517-1.indb 17ACXF55-04370_YZ0517-1.indb 17 6/2/2017 2:30:35 PM6/2/2017 2:30:35 PM
To Next Page
Loading...
