156
Connection network using WPS mode (method 1)
1
Press the WPS button on the router that
will be connected to the air conditioner.
• Check that the Wireless LAN LED is ON.
If the Wireless LAN LED is OFF, press
the Wireless LAN
button to turn it on,
and enable Wireless LAN connection.
Connection Guide
Step 1
Step 2
Step 3
Next
Cancel
2
Check that the Wireless LAN LED is ON.
Press the Wireless LAN
button for 5
seconds until “1” appears on the remote
control. Point the remote control to the
air conditioner and press
SET
.
Connection Guide
Step 1
Step 2
Step 3
Cancel
Next
SET
CANCEL
4
If the Wireless LAN LED keeps blinking,
check the wireless router connection.
Searching for air-condi oner.
Please wait…
Connection Guide
Step 1
Step 2
Step 3
Cancel
3
When the air conditioner is successfully
connected to the router, the Wireless LAN
LED stops blinking and turns ON.
Connection Guide
Step 1
Step 2
Step 3
When the connec on of air-condi oner to router
is successful, the Wireless LAN LED changes from
blinking to ON.
*It may take up to few minutes before changes
to ON.
Next
If the Wireless LAN LED is ON, tap “Next”.
If Wireless LAN LED keep blinking, tap “Check”
Cancel
Check
To Next Page
Loading...
