To Next PageTo Next PageWhat to do if my Panasonic CS-Z80TKR Air Conditioner unit does not work?
If your Panasonic Air Conditioner isn't working, first check if the circuit breaker has tripped. Also, verify that no timers have been set, as this could prevent the unit from turning on.
What to do if the Panasonic CS-Z80TKR remote control does not work?
If the remote control for your Panasonic Air Conditioner isn't working, first, ensure the batteries are inserted correctly. If the display is dim or the signal is weak, try replacing the batteries with new ones.
How to improve the efficiency of HEAT/COOL mode on my Panasonic Air Conditioner?
If your Panasonic Air Conditioner isn't heating or cooling efficiently, ensure the temperature is set correctly. Also, close all doors and windows to prevent air leakage. Clean or replace the filters, and clear any obstructions at the air inlet and outlet vents.
Why is my Panasonic Air Conditioner not receiving the signal from the remote control?
If your Panasonic Air Conditioner unit isn't responding to the remote control, make sure the receiver on the unit isn't obstructed. Also, be aware that certain fluorescent lights may interfere with the signal transmission.
How to fix a noisy Panasonic CS-Z80TKR Air Conditioner?
If your Panasonic Air Conditioner is noisy during operation, check whether the unit has been installed on an incline. Also, make sure the front panel is closed properly.
General| Type | Split System |
|---|---|
| Cooling Capacity | 8.0 kW |
| Refrigerant | R32 |
| Power Supply | 220-240 V, 50 Hz |
| Energy Efficiency Class Cooling | A+++ |
Step-by-step guide for inserting batteries into the remote control.
Important warnings and symbols for safe appliance operation, including refrigerant risks.
General safety rules for power supply and remote control to prevent hazards.
Ensuring earthing, preventing electric shock, and specific measures for R32 refrigerant.
Cautions for indoor/outdoor units, remote control batteries, and power cord handling.
Guidance for seasonal checks, preparing for non-use, and identifying non-serviceable conditions.
Procedure to retrieve error codes using the remote control when the unit stops.
