HOW TO OPERATE
Auto, Heat, Cool, Dr y
■
Operation Details
AUTO - Automatic Operation
• The unit will automatically select
the operation mode according
to the setting, outdoor and room
temperature. During operation mode
selection, power indicator blinks.
For every 30 minutes, the operation
mode is reselected.
!54/
(%!4
#//,
$29
2
/&&
/&&
4)-%2
/.
4)-%2
&!.
30%%$
1
Start the
operation.
HEAT - Heating Operation
• Enables you to enjoy the warming
effect at your preferred setting
temperature.
• For cold air prevention, air might
not blow out immediately and power
indicator blinks when operation starts.
• Also operates in defrost mode
(maximum 12 minutes) where by the
power indicator blinks. The melted
frost is drained at outdoor unit and
indoor fan is stopped.
COOL - Cooling Operation
Select the
desired
MODE
OFF/ON
FAN SPEED
• Enables you to enjoy the cooling
effect at your preferred setting
temperature.
operation.
!54/
$29 (%!4
#//,
POWERFUL
QUIET
TIMER
ON
AUTO
AIR SWING
MANUAL
SET
DRY - Soft Dry Operation
• Enables you to set the desired
temperature at low fan speed which
provides you with dehumidifying
surroundings.
1 2 3
OFF
CHECK
CANCEL
CLOCK RESET
INVERTER
3
Set the
temperature.
(16°C ~ 30°C)
●
Powerful and Quiet operations can be activated in all
operation modes.
●
Press
OFF/ON
button again to stop the operation.
Hints
●
To save electricity, close the curtains when using air conditioner to prevent sunlight and heat from coming in.
●
Heat is obtain from outdoor air to warm up the room. Use an additional heater when the outdoor ambient temperature is low.
Troubleshooting
●
The room has a peculiar odour.
This may be a damp smell emitted by the wall, carpet, furniture or
clothing in the room.
●
Air conditioner does not cool or heat efficiently.
Ensure the temperature has been set correctly.
Ensure windows and doors have been closed properly.
Ensure filters are cleaned or replaced when necessary.
Ensure inlet and outlet vents of the units have not been obstructed.
5
To Next Page
Loading...