EasyManua.ls Logo

Panasonic CW-XC100VK - Page 17

Panasonic CW-XC100VK
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10.3.10. Setting The On Timer
Touch Control Panel Remote Control Display
Press the
TIMER
button.
The
TIMER
indicator light will blink awaiting for setting.
Press the
TEMP/TIMER Upward
or
Downward
button
until the preferred hour of operation is reached.
Press the
SET/CANCEL
button to complete the setting. At this
time, the
TIMER
indicator light is steady instead of blinking.
NOTE
The display will show the remaining hour to the start of the
operation (if you set to turn on 3 hours from now, the timer will
show
2
at an hour later). When set time is reached, the air
conditioner starts the operation under the previous setting
mode and the
TIMER
indicator will light off. Now, the previous
set mode and the fan speed will light up. Simultaneously, the
display will show the setting temperature.
10.3.11. Check Temperature / Mode / Fan Speed Setting During On Timer
Touch Control Panel Remote Control Display
Press the
TIMER
button. The
TIMER
indicator light will blink
and the previous temperature setting will be shown.
Simultaneously,
MODE
and
FAN SPEED
indicator will light up.
This indication will last for 5 seconds, and then the display will
show the remaining time.
MODE
and
FAN SPEED
indicator
light will turn off. At this time, the
TIMER
indicator light is steady
instead of blinking.
10.3.12. Change Temperature/Mode/Fan Speed Setting During On Timer
Touch Control Panel Remote Control Display
Press the
SET/CANCEL
button to cancel the timer setting.
Press the
OPERATION
. Set the desired mode and the fan
speed.
Then press
OPERATION
button to stop operation.
Start the
TIMER
setting again by repeating the step from the
Setting The On Timer
procedures.
10.3.13. Cancel Timer Setting During On Timer
Touch Control Panel Remote Control Display
Press the
SET/CANCEL
button to cancel the timer setting. The
SET/CANCEL
indicator light will turn off.
To operate the air conditioner before reaching the set timer:
Press the
SET/CANCEL
to cancel the timer.
Press the
OPERATION
button to turn on the unit.
17
CW-XC100VK / CW-XC120VK

Other manuals for Panasonic CW-XC100VK

Related product manuals