—16—
3. Loosely assemble the sill support using the parts
in
Figure
23.
4. Select the position that will place the sill
support near the outer most point on sill
(See
Figure
23)
NOTE: Be careful when you install the cabinet (frame
guides
are broken easily).
5. Attach the sill support to the cabinet track hole in
relation to the selected position using
2 Type A screws in each support (See
Figure 24).
6. The cabinet should be installed with a very slight
tilt(about 12.7mm
1
/2") downward toward the
outside (See Figure 25).
Adjust the bolt and the nut of sill support for
balancing the cabinet.
7. Attach the cabinet to the window stool by
driving the screws (Type B: Length sixteen
millimeters and below.) through the front angle into
window stool 16mm (5/8").
8. Pull each Frame curtain properly to each window
sash track, and repeat step 2.
9. Attach each Frame curtain to the window sash by
using screws (Type C).
(See Figure 26)
Figure 23
Figure 24
Figure 25
Figure 26
To Next Page
Loading...
