Panasonic CW-XC103HU - Page 24

—24—
Possible Trouble 5 Remote controller does not operate.
It displays abnormally on display PCB Ass’y.
NO
NO
NO
NO
YES
YES
YES
Is the IC01G all right?
Is the connection of
CN-DISP all right?
• Exchange the display
PCB Ass'y.
• Exchange IC01G.
• Exchange Q01G, Q02G,
Q03G, Q04G.
• Connect connector
to CN-DISP exactly.
Does the Q01G,
Q02G, Q03G, Q04G operate normally
on main PCB Ass'y?
• Check the PCB pattern.
Is the voltage of Battery
about over 2.3V?
• Exchange Receiver Ass'y.
Is the connection of
CN-DISP2 all right?
Is the voltage No.17
of CN-DISP on Main PCB
Ass'y DC 5V?
• Exchange the battery.
• Check the PCB pattern.
• Connect connector to
CN-DISP2 exactly.
NO
NO
NO
YES
YES
YES
Possible Trouble 6