Panasonic CZ-RTC2

3-47
Control of 2WAY SYSTEM
1
2
3
4
5
6
7
8
9
3. Timer Remote Controller
If button does not work.
Or if the operation does not start even if is pressed.
Check the following table.
Item Display of the remote control unit
(Lighting/flashing indication)
Contents
1
The Error indication flashes
(for several seconds).
The clock is not set.
2
“This function is not available” indication lights up
(for several seconds).
When the operation mode is set to AUTO or FAN, this function is not
available.
3
Centralized control indication flashes
(for several seconds).
The centralized control device is prohibited from starting/ stopping the
unit or change the temperature setting.
The sleeping function operation will be cancelled in the following cases:
1: When the unit is operated to stop or change the temperature setting by the other remote control unit or centralized control device.
2: When the unit is operated to stop or change the temperature setting with the weekly program function / outing function.
3: When the centralized control unit is prohibited from stopping the unit or changing the temperature setting.
NOTE
Trouble Possible Cause/Remedy
The temperature setting does not decrease (increase). The temperature over the upper or lower limit or each operation mode
cannot be set.
Operation under the sleeping function does not finish. Note if you change the time after the sleeping function started. The
operation does not finish until it reaches to the set starting time.
Sleeping Function (Continued)
TD831151-002WAY.indb47TD831151-002WAY.indb47 2011/01/1317:08:002011/01/1317:08:00