9
Exposed type
3
*It is also possible to mount in the order
2
→
1
→
3
.
Screw
(Supplied)
Claw (2 locations)
Claw (2 locations)
1
Mount the bottom case to the wall.
● Pass the wire through the wiring
hole in the bottom case and lay the
wire out along the groove.
Mount the top case.
●
Align the claws of the top
case and then align the
claws of the bottom case.
Cut here with
a nipper and
remove the burr
with a file.
Connect the remote control wiring.
• Be sure not to allow unnecessary wires to remain
in the remote controller case when wiring. Be
careful not to allow wires to be in contact with
parts on the PCB. For connection method, refer
to
“
Connection to the remote controller terminal
board
”
in
“
Attention
”
.
Avoid the
wire being
caught.
Hole for screw
Clamper
(supplied)
•
Insert the clamper from the
position indicated by the arrow,
as shown in the diagram at right.
•
Put the locking part of the
clamper in the channel as
indicated by the arrow.
•
If you lock at the top, it may not
be possible to close the bottom
case.
Remove the coating. Approx. 9 mm
Remove the sheath. Approx. 130 mm
●Make sure the wiring connection is in the
correct direction.
●
There will be a slight diff erence in length due
to the wiring diameter, so make adjustments
on site when performing the installation.
Remote controller
terminal board
Push the sheath
in to the back as
shown on the
illustration.
Insert the wire properly
into the channel on the
bottom case, and make
sure the wire is not
pinched when the case
is attached to the wall.
A protective fi lm is attached on the Control panel.
2
To Next Page
Loading...
