26
(EN)
Setting information list
Setting information icon list
Icon Description Page
The indoor unit is stopped or slight blow operation is in process. –
The indoor unit is turned on after a problem such as a power failure is
resolved.
–
The indoor unit is in defrosting operation. –
Air flow direction is locked on some units. * –
Switching between Heat and Cool/Dry mode is prohibited (Switching to
Auto mode is also prohibited.).
–
Remote control operation is restricted by a central control device. P.8
The indoor unit lter needs to be cleaned. P.18
Time to replace engine oil in the outdoor unit. Replace the oil. (Only
when the gas heat pump air conditioner is used.)
–
“ON/OFF timer” is set. * –
Separate timers are set for each day. * –
Energy saving is on to control energy consumption. * –
The operation capacity of the outdoor unit is restricted. –
Units are operated at the capacity set by schedule. * –
If the set temp is changed, the temp will return to the registered set
temp after a preset time. *
–
Upper and lower set temperature limits have been changed. * –
Operation automatically stops in the set time zone at the set interval. * –
“Repeat off timer” is set. * –
Operation capacity of outdoor unit is controlled in the set time zone to
lower noise. *
–
The temperature sensor of the remote controller is detecting the room
temperature.
–
“Operation lock” is set.
• To unlock:
Press and on the top screen. (Press and hold for 4 seconds
or more.)
P.8
Fresh air is used for ventilation. *
(Only when connecting a heat exchange ventilation unit or connecting
a commercially sold fan)
–
(Continued on next page)
To Next Page
Loading...
