EasyManua.ls Logo

Panasonic DA86C15RCU6 - User Manual

Panasonic DA86C15RCU6
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1.3
1.5
1.7
1.9
2.1
2.3
2.5
-40 -30 -20 -10 0 10 20
Current (A)
80
145
210
275
340
-40 -30 -20 -10 0 10 20
Input Power (W)
250
500
750
1,000
1,250
1,500
1,750
2,000
2,250
2,500
-40 -30 -20 -10 0 10 20
Evaporating Temperature (°F)
Capacity (BTU/H)
110°F 120°F 130°F
Rated Performance Data
Cond. Temp I* Cond. Temp II*
Capacity . . . . . . . . . . . . . . 1,031 Btu/h ±7% 1,140 Btu/h ±7%
E.E.R. . . . . . . . . . . . . . . . . . 5.31 Btu/Wh ±7% 6.20 Btu/Wh ±7%
Current . . . . . . . . . . . . . . . 1.76 Amps 1.67 Amps
Nominal Motor Data
Motor Input . . . . . . . . . . . . . . .194 Watts 184 Watts
Rated Current . . . . . . . . . . . . 1.92 Amps
Type . . . . . . . . . . . . . . . . . . . . RSCR, PTC relay
Locked Rotor . . . . . . . . . . 16.1 Amps
Start Current . . . . . . . . . . 23.1 Amps
Coil Resistances Run . . . . 2.51 Ohms
@ 68°F (20°C) Start . . . 5.46 Ohms
*Test Conditions for Performance Specifications
Test Oil . . . . . . . . . . . . . . . . ISO VG 10
Shell Temp . . . . . . . . . . . . . . 170.0°F / 76.0°C
Condensing Temp . . . . . . . . . (I) 130.0°F / 54.4°C
. . . . . . . . . (II) 105.0°F / 40.6°C
Evaporating Temp . . . . . . . . . -10.0°F / -23.3°C
Ambient Temp . . . . . . . . . . . . 90.0°F / 32.2°C
Gas Superheat . . . . . . . . . . . 90.0°F / 32.2°C
Liquid Sub-Cooling . . . . . . . . 90.0°F / 32.2°C
Electrical Accessories
Overload Protector
Nominal Operating Characteristics
Model Name 4TM758NFBYY
Manufacturer Texas Instruments
Temperature To . . . . . . . . . . . Open: 248 °F ± 9°F / 120°C ± 5°C
Close: 142°F ± 20°F / 61°C ± 11°C
Trip Current . . . . . . . . . . . . . . @158°F (70°C) 4.1 Amps ± 7.5%
@77°F (25°C) 12.0 Amps @ 18 sec. max.
P.T.C. Starting Device
Nominal Operating Characteristics
Model Name PTH490D-AS6R8
Manufacturer Murata Mfg
Base resistance
@ 77°F(25°C) ±20% 6.8 Ohms
Power Consumption (max) 3.5 Watts
Operation time 1.0 to 2.7 seconds
Recovery time (max) 65 seconds
Run Capacitor 15 µF 180 V (min.)
†Although these accessories are listed by UL/CSA for use with this compressor,
Matsushita assumes no responsibility whatsoever for these or any other components
sourced by the refrigeration system manufacturer from third parties.
Panasonic Industrial Company
Refrigeration Products Department
Tel: 201 - 392 - 4249
Fax: 201 - 392 - 4315 Rev#1-5/9
Evaporating Temp.
Condensing Temp. Rating -30°F -10°F +10°F
130°F Btu/h 500 1,031 1,864
Watts 122 194 283
Amps 1.45 1.76 2.21
E.E.R. 4.09 5.31 6.58
120°F Btu/h 542 1,080 1,923
Watts 124 191 273
Amps 1.46 1.75 2.16
E.E.R. 4.36 5.66 7.04
110°F Btu/h 583 1,135 1,958
Watts 125 188 261
Amps 1.46 1.73 2.10
E.E.R. 4.66 6.04 7.51
MATSUSHITA Compressor Single Phase 115V
MODEL# DA86C15RCU6 R-134a 60
Hz
Performance Curves
Voltage Range . . . . . . . . . 103 Volts to 127 Volts @ 60 Hz
Application . . . . . . . . . . . . Low Back Pressure
Compressor Cooling . . . . Static / Fan Cooling
Refrigerant Control . . Capillary Tube
Evaporator
Temp. Range . . . . . . . -31°F to 23°F / -35°C to -5°C
9 – Point Data
P
a
na
s
o
n
ic
®
Question and Answer IconNeed help?

Do you have a question about the Panasonic DA86C15RCU6 and is the answer not in the manual?

Panasonic DA86C15RCU6 Specifications

General IconGeneral
CategoryAir Compressor
ManufacturerPanasonic
ModelDA86C15RCU6
Power SourceElectric
Horsepower1.5 HP
Tank Size6 Gallons
Voltage120V
Noise Level78 dB

Summary

Rated Performance Data

Capacity

Rated compressor capacity under specific test conditions, including Condensing Temp I and II.

E.E.R.

Energy Efficiency Ratio of the compressor at specified operating points.

Current

Operating current draw of the compressor at specified conditions.

Nominal Motor Data

Motor Input

The electrical power input required by the compressor motor.

Rated Current

The specified current rating for the compressor motor.

Electrical Accessories

Overload Protector

Details on the compressor's overload protector and its nominal operating characteristics.

P.T.C. Starting Device

Information regarding the PTC starting device and its nominal operating characteristics.

Dimensions

Tube Dimensions

Specifications for suction, process, and discharge tube dimensions and material.

Overall Dimensions

Key physical dimensions (A-F) of the compressor unit in mm and inches.

General Data

Oil Charge and Type

Details on oil charge volume, net weight, and approved oil types for the compressor.

Compressor Specifications

Information on residual moisture, impurities, and displacement.

Related product manuals