42
9.3.1. Precautions when disassembling /
assembling
1. Body cap must remain installed to prevent it from dust,
dirt, and so on when assembling / disassembling.
2. Do not reuse the screws tightened to metal materials.
New screws must be used when assembling.
3. Do not reuse the Grip Rubbers once being used. New
Grip Rubbers must be used when assembling.
• “Rear Grip”, “Front Grip (R)” and “Front Grip (L)” are sup-
plied not only by single item but also by unit as “Grip Kit”
(Part No.: 1YE1MC891CSZ).
9.3.2. Removal of the Rear Case 1 Unit
(Fig.D1)
19 LCD Unit (Fig.D35) FP7203 (Flex)
Convex x 2
Screw (g) x 4
Convex x 2
LCD Unit
20 Rear Operation FPC
Unit
(Fig.D36) FP7252 (Flex)
Screw (h) x 9
Rear Operation FPC Unit
21 Rear Case Unit (Fig.D37) REC Button
AF ON Button
Q Menu Button
Joy Packing
Joy Button
Rear 3 Button Unit
Jog Dial Packing
Jog Unit
Rear Case Unit
22 Hinge Unit (Fig.D38) Screw (i) x 6
FP4201 (Flex)
Hinge Unit
23 Image Sensor Unit (Fig.D39) Screw (j) x 3
Graphite Sheet A
Adjust Spring x 3
Adjust Support Spring x 1
Radiation Sheet
Image Sensor Unit
24 Shutter Mount Base
Unit
(Fig.D41) Screw (k) x 6
B Mount Ring
B Mount
Mount Spring
Lens Lock Pin Unit
Lens Lock Pin Spring
Shutter Mount Base Unit
No. Item Fig. Removal
To Next Page
Loading...
