Panasonic DC-S1P

7
3 Service Navigation
3.1. Introduction
This service manual contains technical information, which allow service personnel’s to understand and service this model.
Please place orders using the parts list and not the drawing reference numbers.
If the circuit is changed or modified, the information will be followed by service manual to be controlled with original service manual.
3.2. About service of bundled lenses
Please refer to the following service manual about service and maintenance of the bundled lens.
• S-R24105E/PP/GC/GK: Order No.DSC1903005CE
3.3. Important Notice
*When servicing, it is recommended dealing with Clean box. (Refer to “8.2. Clean Box” section of this service manual for details.)
3.3.1. Camera Body Unit
3.3.1.1. About Main P.C.B. (Addition of the operation of rewriting Serial number)
• Before exchanging the Main P.C.B., confirm that the symptom and/or phenomenon is not due to the setting of functions.
• This unit memories the Serial number of camera body in the Flash-ROM (IP2201) of Main P.C.B., and in the case of performing
the Main P.C.B. and/or Flash-ROM (IP2201) exchange, it is necessary rewriting to its original Serial number.
The details of rewriting procedures are refer to the adjustments which is available in Adjustment software
Important:
• When replacing the Main P.C.B. and/or Flash-ROM (IP2201), carry out any of followings.
1. When the camera power can be ON, and camera body and adjustment software can be communicated:
Before replacing the Main P.C.B. and/or Flash-ROM (IP2201), proceed the EEPROM data backup from the unit.
After replacing the Main P.C.B. and/or Flash-ROM (IP2201), overwrite the EEPROM data with backup data from the unit first,
then proceed the adjustment /inspection. (Almost adjustment/inspection items can be omitted.)
Refer to the adjustment instruction in the adjustment software for details.
2. When the camera power cannot be ON, or camera body and adjustment software cannot be communicated:
Almost full adjustment/inspection must be performed after replacing the Main P.C.B. and/or Flash-ROM (IP2201).
Refer to the adjustment instruction in the adjustment software for details.
Notes after replacement:
• Make sure the camera body firmware is latest version.
About Serial number (Reference)
• As this unit's specification, the Serial number of camera body is stored to EXIF date of picture image. So that, the Serial number
of camera body is memoried in the Flash-ROM (IP2201) of Main P.C.B..
Therefore when replacing the Main P.C.B. and/or Flash-ROM (IP2201), this Serial number doesn't coincide and it is necessary
rewriting to the Serial number after replacing.
3.3.1.2. About prohibition of reusing Grip Rubber
• Reusing Grip Rubbers used for this camera is not acceptable as the adhesive force gets weaker once they are peeled off.
New Grip Rubbers must be used when assembling.
• Three types of Grip Rubbers : “Rear Grip”, “Front Grip (R)”,and “Front Grip (L)” are used for this camera.
As these three types of Grip Rubbers are supplied not only by single item but also by unit as “Grip Kit” (Part No.:
1YE1MC891CSZ), please make use of it.