Network Settings
(All factory default settings are indicated with underlined text.)
IP Address/DNS Settings (➡ 94)
Press [OK] to show the following settings.
Connection Test
[--]
IP Address Auto-assignment
[On] [Off]
IP Address
[---.---.---.---]
Subnet Mask
[---.---.---.---]
Gateway Address
[---.---.---.---]
DNS-IP Auto-assignment
[On] [Off]
Primary DNS
[---.---.---.---]
Secondary DNS
[---.---.---.---]
Connection Speed Auto-confi gure
[On] [Off]
Connection Speed Setting
This is enabled only when “Connection Speed Auto-confi gure”
is turned “Off”.
[10BASE half duplex] [10BASE full duplex]
[100BASE half duplex] [100BASE full duplex]
Proxy Server Settings (➡ 95)
Press [OK] to show the following settings.
Initialize
Set the setting of the “Proxy Server Settings” back.
Proxy Address
(The initial setting is blank.)
Proxy Port Number
(The initial setting is “0”.)
Connection Test
[----]
Network Service (➡ 95)
Press [OK] to show the following settings.
Network Lock
You can restrict using VIERA CAST.
Follow the on-screen instructions. Enter a 4-digit PIN with the
numbered buttons when the PIN setting screen is shown. It will
be the common PIN for “DVD-Video Ratings”, “BD-Video
Ratings” and “Network Lock”
Do not forget your PIN.
[On] [Off]
Changing Settings (When “On” is selected)
[Change PIN]
Automatic Volume Control
[On]
[Off] Select “Off” when the audio is warped while using
VIERA CAST.
Picture Zoom
[In]
The picture is enlarged.
[Out] The picture is reduced.
Select
“Out” when display of the contents is truncated.
Others
(All factory default settings are indicated with underlined text.)
Automatic Standby
Select how long the unit remains on when it is not being used.
[2 hours] [4 hours] [6 hours] [Off]
Remote Control
Change the remote control code on the main unit and the remote
control (the two must match) if you place other Panasonic
products close together.
[BD 1] [BD 2] [BD 3]
Use “BD 1”, the factory set code, under normal circumstances.
1 Press [
e
,
r
] to select the code (“BD 1”, “BD 2” or “BD 3”)
and press [OK].
To change the code on the remote control
2 While pressing [OK], press and hold the numbered button
([1], [2] or [3]) for more than 5 seconds.
3 Press [OK].
■ When the following indicator appears on the
unit’s display
The unit’s remote control code
Change the code on the remote control to match the main unit’s
(➡ step 2).
Note
Executing “Shipping Condition” in the Setup menu returns the
main unit code to “BD 1”. Change the remote control code to 1
(➡ step 2).
Clock
Press [OK] to show the following settings.
Automatic Clock Setting
This unit usually obtains time and date information from digital
broadcasts.
But, if the time is not set correctly, set it to “Off” and perform
“Manual Setting”. (➡ below)
[On] [Off]
Daylight Saving Time
Select time offset from the standard time for Summer Time.
Normally select “Automatic”.
If there is a gap between displayed time and actual time, set
this function.
[Automatic] [0 hour] [+1/2 hour] [+1 hour]
Manual Setting
Press [OK] to show the following setting.
To Next Page
Loading...
