Panasonic Digital Cordless Telephone System - Changing from Pulse to Tone; Any Key Answer

21
Applied Operation
4. Changing from Pulse to Tone [Programming required]
To change from dial pulse to tone signals during a call or while you are dialling is possible even if
the exchange line you are using is pulse signalling.
1. Press the [Programming] key.
2. Press the [Asterisk] key.
3. Press the [Programming] key.
5. Any Key Answer [Programming Required]
When you set Any Key Answer, you can reply to incoming calls from an exchange line or extension
line by pressing any key other than the [Power] Key.
1. Press the [Programming] key.
The PS enters the Programming mode.
2. Press the [1] dial key.
3. Set Any Key Answer.
To set any key answer OFF : Press the [0] dail key.
To set any key answer ON : Press the [1] dail key.
Note: • To cancel setting midway, press the [On-hook] key.
4. Press the [Programming] key.
The Programming mode is canceled, and the PS
returns to the previous mode.
1
0
or
1