OV with AUDIO/VIDEO IN Jacks..)
--AN Cable
(Supplied)
Audio In Video In
I ,
To ., ff To
Audio In _U Video In
Set the POWER Switch to CAMERA.
You can now view what the Palmcorder
is recording on your TV.
Or, to playback a tape, set the
POWER Switch to VCR.
You can now playback a recorded tape
on your TV.
Turn your TM ON and set it to LINE
INPUT or S-VIDEO.
Check your TV operating instructions
for further information.
Start playback or begin a recording.
Note:
• Please connect the A/V cable until it stops.
• Make sure the Palmcorder and rv are turned
off while connecting.
TV with S-VIDEO IN Jacks._
For best Chrominance and Luminance it is
suggested to use the S-Video connection if
available on your TV.
OUT
<
ack of T_I
Audio In S-Video In
-AVCable ____ 1
(Supplied)
• To Audio In _ _
\ S-Video Cable To S-Video In
(Not supplied)
You can display the various EVF indications
on your TV by pressing DISPLAY ON TV on
remote control. Press again to remove the
indications.
DISPLAY --
ON TV
OjO O
0,0
........._/,-, \,,r_
.... ,t,=,,,,.2_,or, ,,r,_,,_I
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and to
the Canadian Electrical code in Canada)
that provides guidelines for proper
grounding and, in particular, specifies
that the cable ground shall be connected
to the grounding system of the building,
as close to the point of cable entry as
_oractical.
For assistance, call 1-800-211-PANA(7262)
37
To Next Page
Loading...
