HerearesomeofthebasicindicationswhichwillappearonthePalmcorderEVFandLCD
Monitor.OnlyDateand Time indications will be recorded onto the tape.
[_,_1_vd=1=F:T&vK_]=t,LvAr;T;F-
_LL !
O Battery Remaining ! .l_,
O Tape Remaining , , ,
(AY-DVM3OEA) (AY-DVM60EA)
R0:30 RI:_
1 1
"i_:oo'- -'_d,oo'-
• It Will take several seconds for the tape
remaining indicator to operate after the
tape starts moving.
_ CINEMA Indication
(Menu OSD: p. 59)
_ Digital Zoom and other Digital
Functions (Menu OSD: p. 59)
This display appears when the digital
zoom function has been activated.
Q Playback Effect (Menu OSD: p. 6t)
This display appears when SEPIA or
MONO is selected in VCR menu.
_ Volume Display (p. 29)
The volume bar appears when the
volume of the built-in speaker is being
adjusted.
_Tape Speed Indication
_Menu OSD: p. 59)
Indicates the tape speed (SP or LP).
O Disptay ON/OFF and CountmfTime Code
The indication switches as shown
below when the desired "DISPLAY"
mode is selected from the menu.
(Menu OSD: pp. 60, 62)
• When OFF is selected, all displays
are turned off.
LinearTimeCounter MemoryCounter
t
TimeCode
Memory Counter M 0:00:00
The Palmcorder will stop whenever it
reaches the point where the counter was
previously set to M 0:00:00 dudng audio
dub, fast forward, or rewind.
Time Code 0h00mO0s00f
The Pafmcorder calculates and displays
exactly where you are on any tape in terms
of hours, minutes, seconds, and frames
(30 frames = t second).
• This display cannot be reset.
IMPORTANT NOTE:
• Display must be set to ON for MF, AE,
W.BALANCE or BACK LIGHT indications
to be displayed on the EVF or LCD Panel
when selected.
• C.RESET does not work when DISPLAY
is sat to OFF and T.CODE.
63
To Next Page
Loading...
