iD -- • -- • e
• If the Palmcorder is connected to a power
source, the cassette can be inserted and
ejected without turning the Palmcorder
On.
4PUSHTO2TAPEEJECT
CLOSE
1LCD-OPEN Cassette Compartment
Cover
iBefore you begin
1
Connect the Palmcorder to a power
source. (pp. 11, 12) J
Press LCD-OPEN to unlock the LCD
monitor, and swing it fully open.
Slide TAPE EJECT to open the
Cassette Compartment Cover.
Insert a cassette record tab up,
window side facing out.
Press PUSH TO CLOSE to close the
Cassette Compartment Cover.
• To remove the cassette...
Slide TAPE EJECT to open the Cassette
Compartment Cover and pull the cassette
tape straight out.
Note I
• When inserting the cassette, make sure it is facing the right direction and then push
it in completely.
|:_ i R'T;Ii"lil[, I i i'T:'J_,_i"I_11r;I_1"1_'it &.ii]
, E
Undo the two strap ends from their
buckles.
Thread the strap ends through the
Strap Attachment Rings.
Reinsert the strap ends through their
buckles.
• Make sure the straps are not twisted.
Loosen the strap from the Buckle and
create a loop.
2
Pull the strap firmly through the
Buckle to shorten or lengthen the
strap.
te
7