103
VQT1W46
Others
• Are you trying to play back the motion pictures by directly inserting the card in the card slot of
the TV?
> Connect the camera to the TV with the AV cable (supplied) and then play back the pictures
on the camera. (P90)
> Check [TV ASPECT] setting. (P25)
• Is the camera connected to the PC correctly?
• Is the camera recognised by the PC correctly?
> Set to [PC] in [USB MODE]. (P25, 83)
> Disconnect the USB connection cable. Connect it again while the card is inserted in the
camera.
• Pictures cannot be printed using a printer which does not support PictBridge.
> Set to [PictBridge(PTP)] in [USB MODE]. (P25, 86)
> When using a printer with a trimming or borderless printing function, cancel this function
before printing. (For details, refer to the operating instructions for the printer.)
> When you order photo studios to print pictures, ask the photo studio if the pictures can be
printed with both ends.
> Press [MENU/SET], select the [SETUP] menu icon [ ] and then select the [~] icon to set
the desired language. (P26)
• In dark places, the AF assist lamp (P68) lights red to make it easier to focus on a subject.
• Is [AF ASSIST LAMP] on the [REC] mode menu set to [ON]? (P68)
• The AF assist lamp does not turn on in bright places.
• The surface of the camera may become warm during use. This does not affect the performance
or quality of the camera.
The motion pictures cannot be played back on a TV.
The picture is not displayed fully on the TV.
The picture cannot be transferred when the camera is connected to a PC.
The card is not recognised by the PC. (The built-in memory is recognised.)
The picture cannot be printed when the camera is connected to a printer.
The ends of the pictures are cut at printing.
Others
An unreadable language was selected by mistake.
A red lamp sometimes turns on when the shutter button is pressed halfway.
The AF assist lamp does not turn on.
The camera becomes warm.
DMC-FS15GN-VQT1W46_eng.book 103 ページ ２００８年１２月９日 火曜日 午後７時４６分
To Next Page
Loading...
