VQT3L38 (ENG)
8
Attach is recommended to prevent unintentional opening of the side door
when used in the mountains or near water.
• Check that this unit is turned off.
• Attach the silicone jacket where there is no sand or dust.
Securely attach the silicone jacket to
the camera.
• Attach the silicone jacket carefully. It may get
damaged when attached forcefully.
• Be sure to remove any foreign objects (sand etc.)
or water (sea water etc.) adhered inside the
Silicone Jacket. If not removed, the foreign objects or water may scratch or dirty
the camera. We recommend that you remove the Silicone Jacket from the
camera, rinse, and then wipe away the water with a soft dry cloth.
∫ Maintenance after using
•
Remove the silicone jacket from the unit carefully. It may get damaged when
removed forcefully.
• Take the camera out of the Silicone Jacket, and check that foreign objects (sand
etc.) or water (sea water etc.) are not adhered.
• Rinse with water, wipe off water with a soft dry cloth, and dry the camera in a
well ventilated shaded area.
• Do not dry the camera with hot air from a dryer or similar. It may become
unusable due to deformation.
• Do not use chemicals such as benzine, thinner, alcohol, or cleanser, or soap or
detergents.
• After use, remove the Silicone Jacket. Do not store the camera for a long period
of time with the Silicone Jacket still attached.
Attaching the silicone jacket
DMC-FT3GN-VQT3L38_eng.book 8 ページ ２０１１年２月３日 木曜日 午前８時５７分
To Next Page
Loading...
Need help?
General
