Panasonic DMC-FX37 - Selecting a single picture and printing it; Selecting multiple pictures and printing them

91
VQT1R87
Connecting to other equipment
Note
•
Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
• Turn the camera off before connecting or disconnecting the AC adaptor (DMW-AC5PP;
optional).
• Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
• You cannot switch between the built-in memory and the card while the camera is connected to
the printer. Disconnect the USB connection cable, insert (or remove) the card and then connect
the USB connection cable to the printer again.
• The pictures recorded in clipboard mode, copy them onto a card (P69), and then print them out.
Press 3/4 to select [PictBridge(PTP)], and then
press [MENU/SET].
Selecting a single picture and printing it
Press 2/1 to select the picture and then press
[MENU/SET].
• The message disappears in about 2 seconds.
Press 3 to select [PRINT START] and then press
[MENU/SET].
• Refer to P92 for the items which can be set before starting to print
the pictures.
• Press [MENU/SET] to cancel printing halfway.
• Disconnect the USB connection cable after printing.
Selecting multiple pictures and printing them
Press 3.
Press 3/4 to select an item and then press [MENU/
SET].
• If the print check screen has appeared, select [YES], and print
the pictures.
2
USB MODE
SELECT
SET
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
PC
MENU
1
PictBridge
MENU
MULTI PRINT
1/9
100
_
0001
1/9
1/9
100
100
_
0001
0001
1/9
100
_
0001
PLEASE SELECT
THE PICTURE TO PRINT
SELECT
PRINT
2
OFF
1
CANCEL
SELECT
SET
PRINT START
PRINT WITH DATE
NUM. OF PRINTS
PAPER SIZE
PAGE LAYOUT
SINGLE SELECT
MENU
1
2
MULTI SELECT
SELECT ALL
DPOF PICTURE
FAVORITE
PictBridge
CANCEL
SELECT
SET
MENU
VQT1R87.book 91 ページ ２００８年６月２６日 木曜日 午前９時３５分
Downloaded From camera-usermanual.com Panasonic Manuals