14
• Step 4. Display the Initial Settings:
While pressing [ MENU/SET ] button and "[ RIGHT ] of Cursor buttons" simultaneously, turn the power off.
The "Initial Settings" menu is displayed.
There are two kinds of "Initial Settings" menu form as follows:
[ CASE 1. After replacing Main P.C.B. and/or Flash-ROM ]
[ Except "DMC-FZ300EF/EG/EP and FZ330" models: (SEP0514AA is used as a Main P.C.B.) ]
When Main P.C.B. has just been replaced, 11 model suffixes are displayed as follows. (Three pages in total)
[ Only "DMC-FZ300EF/EG/EP and FZ330" models: SEP0514AB is used as a Main P.C.B. ]
When Main P.C.B. has just been replaced, only 5 model suffixes are displayed as follows. (Two page 5 in total)
[ CASE 2. Other than "After replacing Main P.C.B. and/or Flash-ROM" ]
• Step 5. Choose the model suffix in "Initial Settings": (Refer to "CAUTION")
[ Caution: After replacing Main P.C.B. and/or Flash-ROM ]
The model suffix can been chosen, JUST ONE TIME.
Once one of the model suffix have been chosen, the model suffix lists will not be displayed, thus, it can not be changed.
Therefore, select the area carefully.
Select the area with pressing "[ UP ] / [ DOWN ] of Cursor buttons".
To Next Page
Loading...
