40
VQT2H73
The images from this unit do not appear on the
television.
Picture is distorted.
¾ Make sure that the television is connected to HDMI AV OUT
terminal on this unit. (> 25)
¾ Make sure that the television’s input setting (e.g., VIDEO 1) is
correct.
¾ When “24p Output” is set to “On”, HDMI authentication takes
place where 24p images switch to other images, and a black
screen is displayed. (> 32)
¾ When “24p Output” is set to “On”, jittering may occur while
playing DVD-Video other than 24p images. In this case, turn
“24p Output” to “Off”. (> 32)
¾ An incorrect resolution is selected in “
HDMI Video Format
”,
when the television is connected to HDMI AV OUT terminal.
Set the item again.
¾ Picture may not be seen when more than 4 devices are
connected with HDMI cables. Reduce the number of
connected devices.
¾ The unit and television are using different video systems.
Change the setting to match the equipment you are
connecting with. (> 33, “TV System” in the “TV Aspect /
HDMI Function Settings”)
¾ The system used on the disc doesn't match your television.
jPAL discs cannot be correctly viewed on an NTSC
television.
jThis unit can convert NTSC signals to PAL60 for viewing
on a PAL television. (> 31, “NTSC Contents Output”
in the “Picture”)
Video is not output in high definition.
¾ Confirm that the “HDMI Video Format” in the Setup menu is
set properly. (> 32)
Audio is not output in bitstream.
¾ Dolby Digital Plus, Dolby TrueHD, and DTS-HD audio are not
output in bitstream. To output the bitstream, select “Default
Settings” to restore the factory presets and make proper
settings.
The 4:3 aspect ratio picture expands left and right.
Screen size is wrong.
¾ Use the television to change the aspect. Refer to your
television’s operating instructions.
¾ When using an HDMI cable, change “TV Aspect” type to “4:3
Pan & Scan”. (> 32)
No sound from other speakers.
¾ Check all connections and settings. (> 25)
Cannot hear the desired audio type.
¾ Audio may not be heard when more than 4 devices are
connected with HDMI cables. Reduce the number of
connected devices.
Cannot switch audio.
¾ When connecting an amplifier/receiver using an HDMI cable,
you cannot switch the audio if “Dolby D/Dolby D +/Dolby
TrueHD” or “DTS/DTS-HD” is set to “Bitstream”. Set “Dolby
D/Dolby D +/Dolby TrueHD” or “DTS/DTS-HD” to “PCM”.
(> 31)
Music on an SD card cannot be played.
¾ Data that can be played from an SD card are AVCHD,
MPEG2 and JPEG data. (> 7)
The contents of the card cannot be read.
¾ The card is not compatible or the contents on the card may
be damaged. (> 7)
¾ Turn off and then turn on the unit again.
Connection
Card
DMPB100EB-VQT2H73_eng.book 40 ページ ２０１０年１月１５日 金曜日 午後９時１９分
To Next Page
Loading...
