Panasonic DMP-BD Series - Rear Panel and Digital PCB Removal; Rear Panel and BDP;Digital PCB

22
2. Attach Tray door ass’y in order from to
: Insert the shaft in the hole.
: Insert the shaft in the hole.
3. Confirm the Tray door spring is attached as following.
9.1.6. Rear Panel
1. Remove the Fan Connector from Power P.C.B.
2. Remove the 5 Screws (A) and Screw (B).
3. Remove the 3 Screws (C). (BD80 only)
4. Unlock 2 locking Tabs (A) to remove the Rear Panel.
9.1.7. BDP/Digital P.C.B. Module
1. Remove the 4 Screws (A) to remove Front Angle.