RQT9243 or RQT9350
8
Audio and video information
About audio from audio output terminals
Before connecting, read the table below, and confirm the desired audio type and necessary settings (“BD-Video Secondary Audio”, “Dolby D/Dolby
D +/Dolby TrueHD” or “DTS/DTS-HD”). (> 9)
≥The number of channels listed is the maximum possible number of output channels.
HDMI AV OUT/DIGITAL AUDIO OUT (Coaxial [BD55]/Optical)
AUDIO OUT (Analog)
≥Also, depending on the specifications or the settings of the amplifier/receiver, the results of the output may vary.
*1 When the connected equipment is not supported with these audio formats, the audio is output as Dolby Digital bitstream, DTS Digital Surround
bitstream or down-mixed 2ch PCM (e.g., TV).
*2 [BD-V]: When playing BD-Video without secondary audio or clicking sound, the audio is output as the same format as if “BD-Video Secondary
Audio” was set to “Off”.
*3 When the connected equipment is not supported with multi channel surround, the audio is output as down-mixed 2ch PCM.
*4 [BD-V]: When the connected equipment is supported with 7.1 channel surround, the audio output is amplified from 5.1ch or 6.1ch to 7.1ch
depending on the DTS, Inc. specifications.
*5 With PCM output, Dolby Digital EX becomes PCM audio decoded as Dolby Digital, DTS-ES recorded to DVD-Video becomes PCM audio
decoded as DTS Digital Surround, and DTS-ES recorded to BD-Video becomes PCM audio decoded as DTS-ES.
*6 [BD-V]: When “BD-Video Secondary Audio” is set to “On”, Dolby Digital EX is output as Dolby Digital and DTS-ES is output as DTS Digital
Surround, however if playing BD-Video without secondary audio or clicking sound, the audio is output as the original format.
Enjoying High Bit rate Audio of BD-Video [BD-V]
This unit supports high bit rate audio (Dolby Digital Plus, Dolby TrueHD, DTS-HD High Resolution Audio and DTS-HD Master Audio) adopted in
BD-Video.
In order to enjoy these audio formats, the following conditions are necessary. (Part shown in the shaded area of table given above)
NECESSARY CONNECTIONS
≥HDMI AV OUT terminal:
Connect this unit to your amplifier/receiver supporting HDMI (High Bit rate Audio) using a High Speed HDMI cable
(> 11).
≥7.1ch AUDIO OUT terminal [BD55]: Connect this unit to your amplifier/receiver supporting 7.1 channels using audio cables (> 12).
NECESSARY SETTINGS (> 9)
≥Set “BD-Video Secondary Audio” to “Off”.
≥HDMI AV OUT terminal: Set “Dolby D/Dolby D +/Dolby TrueHD” or “DTS/DTS-HD” to “Bitstream” or “PCM” .
≥7.1ch AUDIO OUT terminal [BD55]: Set “Analog Audio Output” to “7.1ch”.
≥The clicking sound on the menu and audio with secondary video in picture-in-picture mode (> 21) is not output.
Terminal HDMI AV OUT DIGITAL AUDIO OUT
“Dolby D/Dolby D +/Dolby TrueHD”/
“DTS/DTS-HD”
“Bitstream”*
1
“PCM”*
3
“Bitstream” “PCM”
“BD-Video Secondary Audio” “On”*
2
“Off” “On” “Off” “On”/“Off” “On”/“Off”
Dolby Digital/
Dolby Digital EX
*
5
Dolby Digital/
Dolby Digital
EX*
6
Dolby Digital/
Dolby Digital EX
5.1ch PCM
Dolby Digital/
Dolby Digital
EX*
6
Down-mixed
2ch PCM
Dolby Digital Plus
Dolby Digital
Dolby Digital
Plus
5.1ch PCM*
2
7.1ch PCM Dolby Digital
Dolby TrueHD
Dolby TrueHD
DTS Digital Surround/
DTS-ES*
5
DTS Digital
Surround/
DTS-ES*
6
DTS Digital
Surround/
DTS-ES
[DVD-V]: 5.1ch PCM
DTS Digital
Surround/
DTS-ES*
6
[BD-V]: 7.1ch PCM*
4
DTS-HD High Resolution Audio
DTS Digital
Surround
DTS-HD High
Resolution
Audio
7.1ch PCM*
4
DTS Digital
Surround
DTS-HD Master Audio
DTS-HD Master
Audio
7.1ch LPCM
Down-mixed
5.1ch PCM
7.1ch PCM
Down-mixed
5.1ch PCM*
2
7.1ch PCM
Down-mixed
2ch PCM
Terminal 7.1ch AUDIO OUT [BD55]
5.1ch AUDIO
OUT
[BD55]
2ch AUDIO
OUT
“BD-Video Secondary Audio” “On” “Off” “On”/“Off” “On”/“Off”
Dolby Digital/
Dolby Digital EX
5.1ch
5.1ch 2ch
Dolby Digital Plus
5.1ch*
2
7.1ch
Dolby TrueHD
DTS Digital Surround/
DTS-ES
[DVD-V]: 5.1ch
[BD-V]: 7.1ch*
4
DTS-HD High Resolution Audio
7.1ch*
4
DTS-HD Master Audio
7.1ch LPCM
Down-mixed
5.1ch*
2
7.1ch
DMP-BD55_35PP-RQT9243_ENG.book 8 ページ ２００８年８月２９日 金曜日 午前１０時２８分
To Next Page
Loading...
