Panasonic DMP-BDT100 - STEP 2: Connecting to an amplifier;receiver; Via an HDMI AV OUT terminal

10
VQT2U33
STEP 2 : Connecting to an amplifier/receiver
Digital Audio
∫ Via an HDMI AV OUT terminal
– It is possible to playback 3D videos when the
connected TV and amplifier/receiver are 3D
compatible.
∫ Via an OPTICAL terminal
≥ Set “HDMI Video Mode” and “HDMI Audio Output” to “On”
(> 30).
≥ Set “Digital Audio Output” depending on the connected
amplifier/receiver (> 29).
≥ The HDMI connection supports VIERA Link “HDAVI
Control” (> 25).
≥ When connecting to an amplifier/receiver that is not 3D
compatible, you can enjoy 3D videos by connecting this
unit to the TV via an HDMI terminal (> 8), and to the
amplifier/receiver via the OPTICAL terminal.
≥ When connecting a TV (> 8) with HDMI AV OUT terminal,
set “HDMI Audio Output” to “Off” (> 30).
≥ Set “Digital Audio Output” depending on the used terminal
and connected amplifier/receiver (> 29).
HDMI IN
HDMI IN
HDMI IN
Multi channel
speakers
Amplifier/receiver
HDMI cable
HDMI cable
(Only supplied in
DMP-BDT105)
OPTICAL IN
Amplifier/receiver
Optical cable
DMP-BDT100_VQT2U33_eng.book 10 ページ ２０１０年６月１５日 火曜日 午前１１時５１分