Panasonic DMP-BDT330 - Connecting to Audio Systems; HDMI Audio Output Connections

11
VQT4V26
Connections & Settings
Connecting to an amplifier/receiver
Perform either one of the following connections in accordance with your amplifier/receiver input
terminal.
[BDT330] : Use HDMI AV OUT MAIN terminal.
≥ Set “Digital Audio Output” (> 30).
≥ When connecting to a non-3D compatible amplifier/receiver, connect this unit to a TV, then connect
the TV and the amplifier/receiver. Please note, however, that the audio can only be up to 5.1ch.
≥ When using the TV or amplifier/receiver that does not have the indication of “(ARC)”
(non-ARC-compatible) on the HDMI terminal, the amplifier/receiver and TV must also be connected
using an optical digital cable in order to enjoy the TV’s sound through the amplifier/receiver.
You can enjoy richer sound by using the HDMI AV OUT SUB terminal.
≥ Set “HDMI(SUB) Output Mode” to “V.OFF”. (> 30)
– Audio is output in high resolution regardless of compatibility of the amplifier/receiver with 3D.
≥ It is possible to play back 3D videos and 3D still pictures when the connected TV is 3D compatible,
even if the amplifier/receiver is not 3D compatible.
≥ The HDMI connection using HDMI AV OUT MAIN supports HDMI CEC (> 26).
The HDMI AV OUT SUB terminal is not compatible with the HDMI CEC.
HDMI AV OUT
HDMI AV OUT SUB [BDT330]
HDMI IN
(ARC)
HDMI OUT
(ARC)
HDMI IN
Amplifier/receiver
HDMI cable
HDMI cable
[BDT230]
HDMI IN HDMI IN
Amplifier/receiver
HDMI cable
HDMI cable
DMP-BDT330_230_VQT4V26_eng.book 11 ページ ２０１２年１２月２７日 木曜日 午前１１時１３分