- 38 -
Reference
F99
¾ The unit fails to operate properly. Touch [Í/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
NET
¾ While connecting to a network.
NoPLAY
¾ There is a viewing restriction on a BD-Video
or DVD-Video. (> 32)
NoREAD
¾ The media is dirty or badly scratched. The
unit cannot play.
Remove
¾ The USB device is drawing too much power.
Remove the USB device.
Setcode
(“ ” stands for a number.)
¾ The remote control and this unit are using
different codes. Change the code on the
remote control.
Press and hold
[OK] and the
indicated number
button at the same time for more than 5
seconds.
U59
¾ Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
Start
¾ A firmware update will start. Please do not
turn off the unit.
UPDATE /5
(“ ” stands for a number.)
¾ A firmware update is in progress.
Please do not turn off the unit.
Finish
¾ The firmware update is complete.
Messages on the unit’s display
To Next Page
Loading...
