69
3. Remove the Pulley Gear, Belt and Mid Gear.
9.2.4. Traverse Base Ass’y and Slide Cam
1. Perform the step "9.2.3. Pulley Gear and Belt, Mid Gear".
2. Remove the Sheet.
3. Open the connector lock, and disconnect the 4 FFCs.
4. Remove 1 Screw, Heat Sink (B) and the Drive P.C.B.
Caution:
Though the Drive P.C.B. is not supplied as
replacement parts, it must be removed for after
disassembling.
5. Push and remove the 2 Rubbers in the direction of
arrows.
6. Open the connector lock, and disconnect the FFC.
7. Slide the Slide Cam to the right until it can be.
8. Remove the Traverse Base Ass'y with pulling the 2 hooks
to the direction of arrows.
To Next Page
Loading...
