70
9. Remove the Slide Cam.
9.2.5. Drive Gear and Loading Motor
1. Perform the step "9.2.4. Traverse Base Ass’y and Slide
Cam".
2. Remove the Drive Gear.
3. Remove the 2 soldering points and 2 Hooks, and remove
the Loading Motor.
Note: (When attaching)
1. Align the projection with the hole of the Loading Motor
and attach.
2. Fix the lead as below.
3. Fix each FFCs by 2 Hooks (A) and 1 Hook (B).
4. When attaching the tray, slide the Slide Cam to the right
until it can be.
To Next Page
Loading...
