72
The unit automatically
switches into standby mode.
FUNCTION
Error code U59
HARD ERR
Error code U88
ERROR MESSAGES
CUSTOMER SERVICE
Error code U50
Error code U71
Error code U72
Error code U73
Access to the HDD is slow.
!
The HDD (Hard disk drive) is in SLEEP mode.
("SLEEP" appears in the display of the unit).
Error code U61
If you need help
Should problems occur, please try to resolve them by referring to the error sources
described here. If this does not help, you should contact your dealer or customer
service.
Normal disc revolution sounds, atmospheric interference during reception, picture
interference while fast forwarding, and limited reception of the satellite programmes
are not signs of a defective unit. If the disc cannot be played due to poor quality, try it
again with a disc from Panasonic.
Page
!
Switch the unit to Standby mode with .
If the unit does not switch to Standby mode, press for approx. 10 seconds or
unplug it for a minute and then plug it back in.
!
Press to switch on the unit. If this does not solve the problem, contact
customer service with the displayed error code.
/ I
/ I
/ I
î
The numbers following H, U or F indicate the status of the unit.
î
The unit is malfunctioning.
The error code H , U
or F appears.
î
The unit is hot and switches to Standby mode for safety reasons.
î
Wait approx. 30 minutes until the message disappears. Place the unit in a well
ventilated location. Do not block the vents at the back of the unit.
î
The unit has found an error during recording or playback without an inserted disc.
The unit proceeds with the recovery procedure.
This procedure restores the normal operating mode. The unit is not defect.
Please wait until the message goes off.
î
The connected unit is not suitable for connection to HDMI.
î
The HDMI connection does not work perfectly.
î
The connected unit is not suitable for connection to HDMI.
î
The HDMI cable is too long.
î
The HDMI cable is broken.
î
One of the unit’s safety devices may have been activated.
!
Press to switch on the unit.
/ I
î
The unit is not functioning properly.
!
Switch the unit off and back on again.
If this does not solve the problem, contact customer service.
î
A problem occurred during recording or playback of a disc.
The unit is not defective, but is performing a restore procedure.
Wait until the error message disappears from the display.
Unit not functioning.
The disc cannot be ejected.
î
Check the connection to the power supply.
î
The unit is currently recording.
!
With the unit switched off, press STOP and on the unit at the same time
and hold for about 5 seconds. Contact your dealer.
CH
î
The above procedure cannot be executed if the child-safety feature is activated.
!
Switch off the child safety feature.
49
î
The unit is in Standby mode for a Timer programming via external units.
EXT-L appears in the display.
!
Press EXT LINK to switch off recording standby mode.
!
To cancel a recording prematurely, stop the transfer of the recording signal
on the external unit.
6
î
Short circuit in the active aerial. Check the connection.
To Next Page
Loading...
