Panasonic DMR-UBC80 User Manual

Getting started
TQBS0037
19
When selecting “Single Cable System” in
Step 6.
1 Select the “Single Cable Version”.
• Select the setting that matches the version of
your equipment.
• Check the Single Cable Version setting in
advance.
2 Make the settings of user band.
• User Band
You can set C1 to C8. (If you have selected
“Single Cable 2.0 (JESS)”, a value from C1
to C32 can be set.) Set to a User Band not
used by any other device.
• When only one User Band of the Router is
assigned, set “Tuner 2” to “OFF”. Note that
you will not be able to record two
programmes simultaneously.
• User Band Frequency
Set the User Band Frequency with number
buttons.
• User Band PIN
If the single cable router requires a PIN to
access an user band, enter the PIN.
• For details, read the manual of the single
cable router, etc.
3 Select “Start Auto Setup”, then press [OK].
• Set User Band as required.
• Refer to the operating instructions for your single cable
router for information about each item.
Confirm
Select
RETURN
Single Cable 2.0 (JESS)
Single Cable
Single Cable Version
Single Cable - EN50494:
Allow up to 8 user bands
Single Cable 2.0 (JESS) - EN50607:
Allow up to 32 user bands
Unicable II
e.g.,
User Band Settings
OK
Select
RETURN
Start Auto Setup
Please confirm user band settings before starting Auto Setup.
Tuner 1
C1
1284 MHz
User Band Frequency
Off
User Band PIN
User Band
Tuner 2
C2
1400 MHz
User Band Frequency
Off
User Band PIN
User Band
DMR-UBC&UBS80EG_eng.book 19 ページ ２０１７年３月２日 木曜日 午後７時１２分

Panasonic DMR-UBC80 Specifications

General

Brand	Panasonic
Model	DMR-UBC80
Category	Blu-ray Player
Language	English