Getting started
TQBS0037
6
Main unit
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right way up.
• The USB port on the front side does not support
USB HDDs. Connect a USB HDD to the USB port on the
rear side. (> 44, Connecting the USB HDD)
Front
Pull to flip down
the front panel.
1 Disc tray
2 Display (> 7)
3 USB port ( DC 5 V 900 mA)
• This port supports USB 3.0 Super Speed.
4 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
5 CI slot (> 9)
6 Open/close disc tray
7 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
Inserting or removing media
∫ Disc
∫ USB device
DMR-UBC&UBS80EG_eng.book 6 ページ ２０１７年３月２日 木曜日 午後７時１２分
To Next Page
Loading...
Need help?
General
