563
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
3. The Alignment Plates separate by 10 mm from the edges of the stack.
Fig. 3-024
4. When the following stack arrives, steps 1 through 3 above are repeated.
5. The Alignment Plates butt against the stack once again, during which, stitching takes place.
Fig. 3-025
6. The Alignment Plates separate by 10 mm from the edges of the stack, after which, folding and delivery
take place.
Fig. 3-026
7. When the first sheet of the following stack reaches the No. 1 Paper Sensor, the Guide moves to a
position 10 mm from the edge of the stack and prepares for the next alignment operation.
Fig. 3-027
To Next Page
Loading...
