Panasonic DP-3530 - Page 613

613
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
6. Removing the Positioning Plate Unit.
7. Removing the No. 1 and No. 2 Paper Deflecting Plates.
Fig. 5-059
(1) Remove the Saddle Stitch Controller PCB.
(See Fig. 5-063.)
(2) Disconnect 2 Connectors [1], remove 3 Harness
Stops [2], and remove the Harness Leads [3]
from the 2 Edge Saddles [4].
(3) Remove 2 Screws [5], slide the Positioning Plate
Unit [6] once towards the front and remove from
the rear side.
Fig. 5-060
(1) Remove the Rear Cover. (See Fig. 5-003.)
(2) Remove the Lower Rear Cover.
(See Fig. 5-031.)
(3) Remove the Claw [1] of the No. 1 Deflect Plate
Bushing, and pull out the No. 1 Deflect Plate
Shaft [2] toward the rear. (The procedure is the
same for the No. 2 Paper Deflect Plate.)
Fig. 5-061
(4) After detaching the Front Shaft of the No. 1
Paper Deflect Plate [3] from the Front Side Plate,
remove the No. 1 Paper Deflect Plate.
[1]
[4]
[5]
[6]
[3]
[2]
[1]
[2]
1
2
[3]