626
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
4. Adjusting the Buffer Roller Winding Amount
Perform this adjustment in the following instances:
(1) When the Finisher Controller PCB or the EEPROM (Q2) on the Finisher Controller PCB has been
replaced.
(2) When something causes the winding amount to fluctuate
The “winding amount” is the amount of difference between the 1st and 2nd sheets wound onto the
Buffer Roller Device in the freed direction.
Fig. 7-007
a. Set SW3 on the Finisher Controller PCB as indicated.
Fig. 7-008
b. Turn the Copier OFF then back ON again.
c. Set the mode setting on the Copier to “1” and the number of originals (A4 or LTR) to “3” in the staple
mode.
d. Press the copy start key.
• Copying starts, three sheets for the first copy are output as a stack on the Staple Tray, and copying
stops with the copies held at the Exit Roller.
e. Remove the stack of sheets from the Finisher exit taking care to prevent the offset of the output
sheets from changing.
Paper exit direction
2nd sheet
3rd sheet
1st sheet
Winding
amount
1
ON
2 3 4 5 6 7 8
To Next Page
Loading...
